FAA pauses installation of new Juniper routers after the nationwide ground stop

Hardware & Components

FAA Pauses Juniper Router Installations After Nationwide Ground Stop

The FAA paused new Juniper router installations after a Nov. 13 ground stop halted U.S. departures for over four hours. About 400 of 3,648 planned routers are installed; 69 operate.

By
Sophie Lindqvist
Filed
Channel
Hardware & Components
Read
4 min read

Sophie Lindqvist

The FAA has paused new Juniper router installations after the Nov. 13 nationwide ground stop; senators cited by CNN said only 69 of 3,648 planned routers were operating.

About 400 routers had been installed, according to senators cited by CNN. The deployment figures leave most of the planned network outside service.

How much of the FAA router build-out is live?

L3Harris Technologies plans to install 3,648 Juniper telecommunications routers on the FAA air traffic control network. Those figures describe device deployment, not proven network capacity.

Because deployment counts do not reveal traffic capacity, controller coverage or redundancy, the 69 operating routers cannot establish the network's readiness for peak demand conditions.

The pause therefore affects an incomplete build-out rather than a fully deployed 3,648-router system. Investigators still must determine whether the equipment, its installation or its configuration produced the failure.

What did the ground stop disrupt?

The Nov. 13 ground stop halted U.S. departures for more than four hours, affected tens of thousands of flights and was the longest halt of its kind since 9/11, CNBC reported.

Communications and radar feeds at 17 of the FAA's 22 en route air traffic control centers were hit, CNN reported. The number shows wide operational exposure, but it does not identify the failed component.

What do investigators know?

On Sunday, Transportation Secretary Sean Duffy said an overloaded router installed in southern Arkansas appeared to overwhelm systems that feed radar and other data to controllers. The device was installed during an upgrade overseen by L3Harris Technologies to move the FAA network from copper wire to fiber.

Duffy's account points to one installation, not a confirmed network-wide design fault. The FAA has not identified a root cause. Investigators are weighing defective equipment against installation or configuration error. Agencies also say they have no indication of a cyberattack. That leaves the overload theory plausible but unproven.

Why did installation stop?

An FAA spokesperson told CNN the pause covers new Juniper telecommunications routers and has no end date. Installation will remain paused while the agency investigates. The Wall Street Journal first reported the pause. The FAA tied the pause to equipment problems, while investigators continue to separate defective units from installation and configuration mistakes.

L3Harris said it is "working with the FAA to investigate the incident." CNBC said it had asked L3Harris and Juniper for comment.

The FAA has also disabled the function believed to have triggered Friday's failure on more than 60 similar routers, according to a Fox News report. The cited reports do not identify the function or explain how the agency selected affected units. Disabling a function is a containment step, not proof of a cause.

On Tuesday, Democrats on the Senate Commerce Committee requested an immediate halt to new installations. They asked whether the equipment had been adequately tested and why backup systems did not prevent the disruption. They also requested a briefing from the FAA, L3Harris and Juniper by Monday.

Their letter stated: "Identifying the device that failed does not establish why it failed." That distinction matters because the failed unit alone cannot explain the network-wide effects. The cited account does not describe the backup architecture or why those systems did not contain the outage.

The report also noted earlier coverage of the Republican response to Duffy's $50 billion request. The report did not describe that request or connect it technically to the router program.

What remains unresolved?

Three facts remain unresolved: the identity of the suspected function, the reason backup systems did not prevent disruption, and the date when installation can resume. Those gaps matter more than the headline pause because they determine whether the broader 3,648-unit deployment can proceed safely.

Is the aviation safety deal related?

No. House and Senate negotiators reached a deal in principle on Tuesday on aviation safety provisions that had been stalled for nearly a year, Reuters reported.

The package includes aircraft tracking and helicopter safety rules prompted by the January 2025 midair collision near Washington. Reuters did not tie the agreement to the FAA's router network or the Nov. 13 ground stop. Any claimed connection remains unsupported.

The next milestones are a root-cause finding, an explanation for why backups did not contain the outage and a decision on when the 3,648-router rollout can resume. Until then, the operating count will remain below the deployment target, and the broader network will carry unresolved reliability questions.

Source: mlq.ai

Share this article:

More from Sophie Lindqvist

Sophie Lindqvist

Show full bio

News editor covering money, funding and market shifts around Semiconductors, chip manufacturing, hardware, AI compute at Chip Dispatch.

1,113 articles

Related articles

« Previous article